- Width
- 1300 mm
- Height
- 1700 mm
- Length
- 4850 mm
- Brand
- Sormac
- Frequency (hz)
- 50
Sormac carrot
baton line made up of:
-WSM carrot
baton machine
The
semi-automatic carrot baton machine type WSM cuts batons in length and
cross-section sizes.
The machine is very easy to operate. Carrots are manually
fed into the receiving holes in the turret wheel. The carrot is aligned for
topping and slicing by an alignment plate behind the turret wheel.
The turret
wheel rotates at one hole every second, each hole containing one carrot. The
carrot is topped, tailed and sliced into the set length. In the next step, the
carrot is pressed through the grid to give a carrot baton of the desired
cross-section size.
The turret
wheel is available in different hole sizes and section sizes. The
indexing holes can be 40 mm (1,57?), 50 mm (2?) or 60 mm (2,36?) in diameter,
depending on the grade of carrots being used. The wheel sections are dependent
on the required length of the baton. Wheels for 40, 50, 60 or 75 mm (1,57? / 2?
/ 2,36? / 3?) are available.
Usually for carrot batons a 7.5 x 7.5 mm (0,3? x 0,3?) or 10
x 10 mm (0,4? x 0,4?) grid is used.
Product
specification
The minimum
and maximum diameter and length of the carrots depend on the type of turret
wheel which has been installed (hole diameter and baton length).
Capacity: The
maximum capacity is 3,600 carrots per hour.
-Elevating
conveyor
-SR sliver
remover
The Sormac
sliver remover is manufactured with a series of ribbed rollers with an
adjustable distance between each roller. The roller bed is inclined to
create an angle for optimal product transit. The produce flows crosswise over
the rollers with a forward product speed dependent on the angle of the roller
bed and the rotational speed of the rollers. The undersized product falls
through the rollers aided by the external ribbing around the roller and the
whole graded product passes forwarded.
The waste falling through the rollers is caught in a hopper
and collected in a crate or waste conveyor under the machine.
The
distance between the rollers is adjustable between 4 and 28mm by placing fixed
pre-sized spacers between the axles of the rollers. The machine will be
supplied with 3 sets of distant spacers. Sliver removers are used for removing
small misshaped pieces out of parallel shaped cut root vegetables.
The machine is completely constructed of stainless steel.
The roller rotational speed is controlled by a stainless steel drive motor. The
angle of the roller bed can be adjusted to suit individual product types.
Product
specification: The sliver remover is used for parallel shaped cut root
vegetables.
Capacity: The
machine’s capacity depends on the width and the number of rollers within the
machine and the tolerances required within the product specification. Capacities
up to 3,000 kg per hour (6,600 lbs/hr) can be achieved subject to
specification.
Distance
between rollers: 180 mm.
Roller
height: 30 mm